The table in my parents 26RLS seems too wobbly. It's a u shaped booth with the pull out seats at either end of the booth. There are two removable legs similar to these.
Someone mentioned that the screws holding the cups to the floor and table might be loose. Sure enough, I was excited when I found them a little loose and expected better results when I set the table up again but no luck. All the screws are in good but the table is still a bit wobbly if someone leans a bit on an edge.
It could be something as simple as someone lightly cutting a piece of steak and the table will lean a bit to that side. It's not like I'm complaining about someone pushing on the table to get up from the booth. It's just normal, light use that does this.
Like I said, I made sure all the screws are in good and have pushed down hard directly over the legs to get them to seat better. Still not much luck.
Is this just a byproduct of having a table like this? Is there anything we can do to make it sturdier?