Originally Posted by Pappy
I replaced both the shower head and bathroom sink faucet after our first trip. Took about 10 minutes total. Simple disconnect old and connect new. Like OP said, hand tight and it's finished. Plastic fittings on lines under sink have little ears for hand tightening. Just like the ones in my home.
I wish you guys would stop this, or maybe I should ban my wife from this site! She saw it and had to have it. It is a lot better as the new faucet sprays into the center of the sink, as others have stated. I have rigid pex lines running to mine and it was a royal PITA to replace as it was very tight back there. You guys stated "hand tight". I assume that include the supply lines. I had to take a pair of pliers to loosen mine from the old faucet. When I attached them to the new faucet, I tightened them as much as I could by hand, then snugged them another 1/4 turn with pliers. Is that OK or should I loosen them and just tighten again by hand? Can't test it for 2 weeks, unfortunately. $50 at Menards.http://www.jaycoowners.com/forums/at...1&d=1410218557