Only took me a few months, but I finally got around to completing this little project, even though I purchased the replacement switch quite some time ago.
I have a 1207 pup. We have a bad habit of leaving the water pump on when we are away, and/or when the tank is low, which results in the pump running unnecessarily.
Here is my existing switch:
You can see the bezel easily pops off then the switch can be removed:
I purchased a lighted replacement here
for a little over $6.00 including shipping.:
Of course, since the existing switch was not lighted, I needed to provide ground to the switch, which I did through the existing block behind the power converter:
When all was done, I have exactly what I wanted - a switch that is extremely obvious when turned on:
It may not be the most sophisticated mod, but I make sure I turn the pump off every time I am not using my sink.