New owner of a 2003 Granite Rigde 3100SS. Had a bit of an issue with the operation of the furnace at first, shuts down after 30 seconds of running. I lit all three burners to get the propane flowing for about 5 minutes, turned the thermostat to heat and then all is ok. However, the air flow was mimimal. I then took the screen off the cold air return located under the fridge. Then I observed a lot of hot air circulating in the area around the blower. The blower is mounted on a flat board but not centered on the board. It is offset about 2 inches to the right allowing air to come into the space around the heater. Question: Is this normal, if it is then I am loosing a tremendous amount of heated air to the space below the fridge. I can fix but would like some input as to whether I should or leave it this way.
Thanks for your replies.....tinhut