2005 Granite Ridge.
The camper door has a pretty good gap at the bottom, it's enough that the seal isn't touching the frame.
However, the top of the door seems to fit OK and has a good seal.
Door adjustment on the striker seems limited to up/down alignment with the latch. There isn't any in/out adjustment as far as I can tell without physically modifying the striker.
I need that door to go "in" (further closed) to snug up the seal. I can push it about 3/8" by hand and that's all that is needed.
How do you adjust a door that's sealed at the top, but not at the bottom? If at all? Do you slightly bend the door or is there some adjustment that I'm missing?
Striker:
Latch:
Bottom of the door gap:
Top of the door gap: