New Theater seating

[katiedog]

Could someone post a Pic of these seats installed.
I am concerned that the length will limit the adjustment
of the Passenger seat.
We would love to try these in our 31DS if they work.
Thanks

[MadDad]

I started this thread and have some pics on the 1st page. Should be close enough to the ones you're looking for. Mine is the same model RV.

[snowbird47]

Originally Posted by katiedog

Could someone post a Pic of these seats installed.
I am concerned that the length will limit the adjustment
of the Passenger seat.
We would love to try these in our 31DS if they work.
Thanks

Katie - I JUST finished installing the 58" recliner from RecPro (got it in ONE DAY after I ordered it, but then again I live in the Indianapolis area in the summer and the factory is in N. Indiana).
Firstly to calm your fears, the unit actually leaves enough room for the passenger seat to be fully pushed back (which you could not do with the jack-knife). You still will not be able to recline fully however. With the recliner in the upright position, there is still sufficient walking room in the RV with the table slide in, but you do not have room to recline without running the slide out.

The unit goes together quite easily, the only hassle is figuring out how to attach it to the floor. I mounted it to a piece of 1/2" plywood and attached that to the four bolts that hold the seat belts. Even though we will probably never use the belts, I left them attached and they lay behind the recliner on the floor.

[Joe1mc]

Has anyone tried the theatre seating on the Seneca FS replacing the pull out couch? Any pictures or size or dimension of the theatre seating would be helpful.

[Stargazerandu]

Originally Posted by MadDad

Put in a new set of Clay Madison RV Wall Hugger Theater Seats today. Looked for a long time and settled on these. Found them in an old listing on E-bay and called to see if they had anymore. They had some in Espresso brown which was better than the the black one we had seen on their E-bay site. The company is out of Fort Wayne, IN.

championproductsllc on eBay

@ $845 with shipping.

I forgot to take a pic of the old couch/bed that was very uncomfortable.
Here's a couple of pics of the new setup.

I am going to attach the old sidepiece as the old bolts show. I also ran some 120 volt from the storage area where you would use a TV outside to behind the couch. It has heated seats and led lighting, neither of which will be used much, but they are there so might as well hook them up.

Very nice!! Easy to install?

[MadDad]

Originally Posted by Stargazerandu

Very nice!! Easy to install?

Not to bad. Took out the large bolts holding the original couch. Used some shorter screws, about 8 to bolt down the new seats. Put the long bolts back in just to plug up the holes.