auto leveling problem

[TexasRT]

Originally Posted by jtw

I have a lippert 4 point leveling system, the rear jacks are moving down in auto level mode but they are not making contact with the ground, at this point the front jacks level the camper, and system says auto level success. Has this happened to anyone.

I recently had the same issue with my 6 point system. My rear jacks and center stabilizers would not ground themselves during auto leveling. I replaced the rear leveling sensor, reset the zero level calibration and the problem is solved.

[skijlw]

I did not have an error code on my control panel. I had to locate the master control box that was on the ceiling of the basement in the middle. Hook up your TV. Turn off the power and disconnect the connector that goes to the legs giving you a problem. Turn on power and try to operate the legs. This will give you an error. Turn off power and reconnect the wires. Turn on power and do a re-calibration of the unit per the manual. Any problems call the Lipert service dept.

[Hoojs12840]

New issue. My 6 pt leveling will trip the resettable breaker and thegive me the LF Jack error. Tried it 10 times same issue.

What would be causing the breaker to trip and reset self?


Sent from my iPhone using Tapatalk