Issues with auto leveling, new 5th
Ok. So I finally took a 3 hour drive to the dealer and picked up the new seismic and brought it back last night. Among a fee other issues (was somewhat of a rushed demo and will share thoughts on the dealer another day) I'm having issues with this leveling system. This is a Seismic 3914 with 6 points/actuators. It has an LCI panel with an Atwood "brain" and electrical actuators. When I attempt to auto level on a hard pretty level surface, (both axis within less than a couple degrees of level prior to leveling) when the rear jacks begin to raise the rear end they seem to struggle and the motors finally torque out and the panel will either shut off and turn back on and then give an error of "out of stroke" or just go to the error. What's interesting is the middle set of jacks don't do the kiss thee ground test nor do they move to assist the rear jacks. Thoughts? The test at the dealer seemed to go fine, although I was so overwhelmed and saturated given amount to take in and the pace I might have not noticed it errored out or was distracted. They did tell me if I screw up the sequence at all the system goes into confused and screwed up mode. I just think something's not right if the middle jacks don't move. Are they considered rear jacks as well and move in conjunction with the aft set? Long post I know. Thanks for any info in advance. I'm not happy at all about this obviously.
|