Mods to 377 RLBH?

[Magnolia Tom]

Thanks klassic! I'll give it a go

[Fairenatic]

You could also get an HDMI switch if you need the extra connections.

[klassic]

Originally Posted by Fairenatic

You could also get an HDMI switch if you need the extra connections.

Unless the radio of the furrion outputs through the hdmi out, which I doubt, there's no other way.
It's a really poor unit

[SoCADesertRat]

Originally Posted by Magnolia Tom

I took the fridge out. Haven't decided on the cooktop yet. I was thinking of a magnetic catch instead of a strut. We had them in our previous rig and they worked well. I don't like that latch for the outdoor kitchen at all.

Tom, if you used a magnetic latch would you glue or screw the two pieces to the door and trailer side? Totally concur with your opinion on the latch mechanism.

Thanks for your response and myriad of ideas!

[Magnolia Tom]

I would screw them in. Probably use double sided tape first to make sure I got them in the right spot before drilling my holes.

[SoCADesertRat]

Originally Posted by Magnolia Tom

I would screw them in. Probably use double sided tape first to make sure I got them in the right spot before drilling my holes.

And some good sealant, too.

Thanks, Tom

[Magnolia Tom]

Anyone have the backup camera? Can you post a pic of where it is mounted outside? I am going to try a DIY wireless camera but I wanted to see where the factory ones go before I do any drilling. The voyager system is nice but I'm not going to pay that price for one.

[Kahoneys]

Here is a pic of my camera that came with the 377. I cannot get you a better picture for we have gotten 8" of snow in the last 2 hours with at least 4 more to come.

[Magnolia Tom]

Thanks Kahoneys. Did the camera wire's grommet replace the center light? Why did they leave so much wire exposed?

[Kahoneys]

A question I asked the Jayco rep and he couldn't answer it. Open Range (a Jayco Company) has such a nice clean look with no wire exposed. We have 5 lights across the top, the wire goes in near the center light a smidge on the Door Side.

[Magnolia Tom]

Thanks. I think I'm going to give it a go...just need to round up the parts and pieces

[Magnolia Tom]

Got my water softener delivered from Amazon today. It's a bit larger than I thought it would be. I ended up getting an On the Go double model. Need to hook it up to try it out.

[Kahoneys]

Where are you going to put your scuba tank, I mean water softner??

[Magnolia Tom]

[emoji23][emoji23][emoji23] I thought the same thing! I'll put it in the extra propane storage area if needed but I'm sure it'll fit next to the docking station by the cord reel

[klassic]

Unscrew your back wall and have a look in there. Besides the bird nest of wires there is tons of room

[Magnolia Tom]

Originally Posted by klassic

Unscrew your back wall and have a look in there. Besides the bird nest of wires there is tons of room

I'll do that. Didn't think about having it semi permanently installed. I was just going to take it out each time I hooked up

[Justin]

Tom

If you put it in the extra propane storage locker would you rig up all your plumbing so that you could leave it there all the time? I just bought one of these units and I'm also trying to decide where to put it.

[Magnolia Tom]

Justin

I'm debating on where and how I'm going to install mine. I'm considering putting it behind the hook up station. Would be easier and less to plumb but I've got to test out how long I can use it before needing to add salt or backwash. In the propane storage would be easier access but more plumbing to run and try to conceal. Other way is less plumbing and easy to conceal but harder access

[Hoojs12840]

I'm going to add "locking tabs" to my basement panels so I just turn all 4 and the panel comes off.

[Magnolia Tom]

Finally installed my sewer hose storage. Not where I wanted to put it. I wanted it closer to the compartment door but with the drop frame, I would only have about 12" of clearance.