Voyager rear view system

[3330]

Do we have any electronics wizards here? I'm trying to set up a wired rear view system on my rig. I have a B&W Voyager camera mated to a newer model LCD monitor that works well with a direct cable connection. I've tried to split the circuit with a disconnect between the tow vehicle and trailer using a Blue Ox http://www.blueox.com/p-794-4-wire-e...extension.aspx setup. I just can't get the thing to work and I'm wondering if the increased size of the wire in the connector setup is causing too much or too little impedance to the signal. I've emailed ASA tech support but was hoping for some guidance in the meantime. Thanks in advance for any ideas.

[Seann45]

Sorry I cannot help you with that.. This is what I got and it comes with a trailer connect kit..
http://www.rearviewsafety.com/motor-...5th-wheel.html

[3330]

Thanks Seann, That's a great deal. What I did was use a new Voyager system left over from previous endeavors but all it had was the straight cable used in motor homes. They list their disconnect kit for almost $250! So i tried to same some money with the Blue Ox gizmo. I found the correct one at RV Outfitters for $150 and ordered it. So I have my fingers crossed. I would have saved money by ordering the one you have.