Originally Posted by SkyBound
The slide lock is a metal tube with flat ends on both sides, almost looks like a jack.
How difficult is it to adjust a slide from side to side? I had a look at one and with the slide extended, the rubber wiper seal wasn't touching the slide at the very top - had about a 1/4in gap... I remember another 28bhs owner on here describing the same issue. Is this a difficult/expensive fix?
Its been a few years since I adjusted mine but IIRC I just slacked up the bracket bolts, placed a floor jack under the low side of the brace, raised the jack until the slide was level then re-tightened the bolts.
(all this was done inside the trailer, under the sofa.) The process would likely be more involved with a large slide...