Journey with Confidence RV GPS App RV Trip Planner RV LIFE Campground Reviews RV Maintenance Take a Speed Test Free 7 Day Trial ×
Jayco RV Owners Forum
 


Reply
 
Thread Tools Search this Thread Display Modes
 
Old 07-10-2016, 11:30 AM   #1
Junior Member
 
Join Date: Jul 2016
Location: Newhall
Posts: 9
Bedroom electrical sockets stopped working

Any troubleshooting ideas?
They were working fine then nothing, I have a 2014 26RLS.
Fuses are fine, GFI is fine, other sockets in the rest of the trailer work fine.

I'm puzzled.
Kurt is offline   Reply With Quote
Old 07-10-2016, 11:54 AM   #2
Senior Member
 
Iraqvet05's Avatar
 
Join Date: Mar 2013
Location: Kansas City
Posts: 1,710
Fuses only apply to the 12V items like lights and the fridge. I don't believe the bedroom outlets would be on GFI since they are not near a water source. I would start by turning off the breakers then turning them back on. Sometimes a breaker will trip but not appear to be tripped. If that doesn't work, I'd pull the circuit panel from the wall (shore power disconnected) and make sure the wires at the breakers are tight.
__________________
2018 28BHBE
2017 Ford F250 XLT, 6.2 gasser
2013 26BH (traded)
Iraqvet05 is offline   Reply With Quote
Old 07-10-2016, 12:26 PM   #3
Junior Member
 
Join Date: Jul 2016
Location: Newhall
Posts: 9
Thanks
I did the breaker off and in thing, and I noticed when they are off a red led lights up to indicate it's tripped or off.
Where and how do I remove the wall circuit panel?
Kurt is offline   Reply With Quote
Old 07-10-2016, 01:05 PM   #4
Senior Member
 
Iraqvet05's Avatar
 
Join Date: Mar 2013
Location: Kansas City
Posts: 1,710
Not sure about yours but mine has a few screws holding the trim cover over the panel. One the cover panel is off, there are about 16 screws that hold the panel to the plywood behind it. Another possibility is an outlet in that circuit is bad and not feeding the downstream outlets.
__________________
2018 28BHBE
2017 Ford F250 XLT, 6.2 gasser
2013 26BH (traded)
Iraqvet05 is offline   Reply With Quote
Old 07-10-2016, 01:09 PM   #5
Junior Member
 
Join Date: Jul 2016
Location: Newhall
Posts: 9
Thank you
Kurt is offline   Reply With Quote
Old 07-11-2016, 03:51 AM   #6
Senior Member
 
robkelly's Avatar
 
Join Date: Nov 2013
Location: Duxbury
Posts: 7,113
Had that same issue on our WH. Turned out that one of the wire nuts in a junction box had come loose. Not sure about your rig, but our junction boxes were behind the control panel and behind the carbon monoxide detector - not the easiest to get to. Just be sure you're unplugged from shore power before messing in the control panel and junction boxes - from experience, you'll get quite a jolt if you touch the wrong wire while the power is on.
__________________
Rob & Kelly, Bella & Brady (Miniature Schnauzers)
2022 Eagle HT 28.5RSTS
2017 RAM 3500 SRW CTD/AISIN CC LB
robkelly is offline   Reply With Quote
Old 07-11-2016, 06:37 AM   #7
Senior Member
 
RoyBraddy's Avatar
 
Join Date: Sep 2011
Location: King George
Posts: 2,761
I have GFCI receptacles in three places on my 5th wheel.... Kitchen Sink area, Bathroom area, and washup sink area in the bedroom...

When they trip many receptacles down the line goes OFF too...

What new Electrical things have you added recently...

Roy Ken
__________________
Roy and Carolyn
I claim Horse Creek Country in Southern Ill - Momabear is from North Texas
We live in King George VA
RETIRED DOD DOAF DON CONTRACTOR Electronics Tech 42YRS

"We're burning daylight" - John Wayne
2008 STARCRAFT 14RT OFF-ROAD POPUP with PD9260C and three 85AH 12VDC batteries
2010 F150 FX4 5.4 GAS with 3.73 gears - Super Cab - Towing Package - 2KW Honda EU2000i Gen
K9PHT (since 1957) 146.52Mhz
"We always have a PLAN B"
RoyBraddy is offline   Reply With Quote
Old 07-11-2016, 07:12 AM   #8
Senior Member
 
Seann45's Avatar
 
Join Date: Jun 2010
Location: Saskatoon Sask Canada
Posts: 10,714
Trip the GFI then reset it and see if that helps.. sometimes they need a "Gibbs head slap"
__________________
Seann
2004 Chev Silverado Duramax optioned past the max. 2009 Jayco Eagle 308 RLS 900watts of solar, Lithium batteries (400amp hour), 2000 watt (4000 surge) whole house inverter.
145days boondockinig in2023 2022/151 2021[/COLOR]
93/2020,157/2019219/2018 206/2017,215/2016, 211/2015, 196/14, 247/13, 193/12

Seann45 is offline   Reply With Quote
Old 07-11-2016, 07:51 AM   #9
Junior Member
 
Join Date: Jul 2016
Location: Newhall
Posts: 9
Ok, so I got home from our trip and everything is back working again. My wife thinks a loose wire somewhere.
I may need to pull sockets out one at a time to check wiring,
Thanks everyone.
Kurt is offline   Reply With Quote
Old 07-13-2016, 10:32 PM   #10
Junior Member
 
Join Date: Jul 2016
Location: Wichita Falls
Posts: 10
During our first trip we lost power to all outlets except the one the microwave was plugged in to. Our gfci wouldn't reset either. It ended up being the outside outlet had a wire that wiggled loose. the wires are just inserted and tightened with the screw, but after replacing all the outlets in our house I've found that curling the wire around the screw and tightening is far better. I'd bet you have something loose somewhere.
Lauren is offline   Reply With Quote
Old 07-14-2016, 12:37 AM   #11
Junior Member
 
Join Date: Jul 2016
Location: Newhall
Posts: 9
Thank you Lauren I think you may be right about having a loose wire.
When we got home everything was back working again.
I think I'll start pulling one at a time out and checking for good connections.
Kurt is offline   Reply With Quote
Old 07-19-2016, 07:47 AM   #12
Junior Member
 
Join Date: Jul 2016
Location: Wichita Falls
Posts: 10
Did you figure out the issue? Ours tripped the GFCI again on our third trip and it's still not working! We checked every receptacle except the one the refrigerator is plugged into because its surrounded by spray foam and I'd rather have the dealer take care of that. I'm guessing that has to be where it's at, thankfully we have the one outlet the microwave is plugged Into that's on a different circuit so we have been using an extension cord and power strips for cpap and charging cell phones
Lauren is offline   Reply With Quote
Old 07-19-2016, 08:00 AM   #13
Junior Member
 
Join Date: Jul 2016
Location: Newhall
Posts: 9
Magically when we got home everything was working again.
Stay tuned.
Kurt is offline   Reply With Quote
Old 07-19-2016, 08:03 AM   #14
Senior Member
 
Join Date: Jun 2015
Location: Nashville
Posts: 470
Yeah but the problem still exists. A loose connection is just a fire looking to start. I always tape the wire nuts in a moving vehicle to keep them from backing off due to vibration.
Hohenwald48 is offline   Reply With Quote
Old 07-19-2016, 08:09 AM   #15
Junior Member
 
Join Date: Jul 2016
Location: Newhall
Posts: 9
Agreed! Just haven't had the time to troubleshoot and check them all. Next trip is end of August, I need to get started on checking things soon.
Kurt is offline   Reply With Quote
Old 07-19-2016, 08:19 AM   #16
Junior Member
 
Join Date: Jul 2016
Location: Wichita Falls
Posts: 10
Quote:
Originally Posted by Hohenwald48 View Post
Yeah but the problem still exists. A loose connection is just a fire looking to start. I always tape the wire nuts in a moving vehicle to keep them from backing off due to vibration.
We don't have wirenuts! Our outlets are the ones you push the wires in. I pulled out all the outlets to check them and only found one where the ground wire still had paper on it.
Lauren is offline   Reply With Quote
Reply

Thread Tools Search this Thread
Search this Thread:

Advanced Search
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Trackbacks are Off
Pingbacks are Off
Refbacks are Off


» Featured Campgrounds

Reviews provided by

Powered by vBadvanced CMPS v3.2.3
Disclaimer:

This website is not affiliated with or endorsed by Jayco, Inc. or any of its affiliates. This is an independent, unofficial site.


All times are GMT -6. The time now is 02:43 AM.


Powered by vBulletin® Version 3.8.8 Beta 1
Copyright ©2000 - 2024, vBulletin Solutions, Inc.
Copyright 2002-2016 Social Knowledge, LLC All Rights Reserved.