So after sanitizing my water system I decided to run some of the baking soda solution in to the black tank. I filled up the toilet, then flushed. I went outside then came back in and noticed a whole bunch of water around the toilet. Long story short, if I press the foot pedal lightly the bowl fills slowly and water comes out of the top of the valve at the top of the toilet just under the seat, but if I press the pedal to the floor then back off just enough for it to close the bowl will fill with water.
Anyone have any ideas what this is? Am I just not doing it right, is it supposed to allow water out the top of the valve? I was only using the water pump and not the city water. I did not see any leak when I winterized it.
2010 Starcraft Autumn Ridge 186BH
2012 Dodge Ram 1500 Sport, 5.7L Hemi, 3.92 axle.