I am wiring in a new Atwood 10-E water heater, with a new combo switch, into a 2000 Jayco Eagle. To finish the wiring I need to supply 12 volt positive line and a 12 volt negative from the converter to the combo switch. How do I go about bringing them in?
The negative usually just goes to the trailer frame.
The positive wire. You need to snoop for a routing. On my 23B I followed the water pipes, used a wire fish tape and connected a long nylon line to it, then I pulled the wire with the line. I connected to fuse panel in an unused slot.
Another option is to drill down through the floor and run the wire under the tt.
Thank you for assisting me in my first venture into ac/dc. It was much simpler than I thought, but when I don't know questions are wise. A friend, who is an electrician, inspected my work and showed me how to make the dc connections. The water heater is working well. Thank you!!!!!!!!!!!!