Pulling 20Amp Fuse for Slideout Motor
I have my slide-outs braced and supported on slide-out jack stands. Since I have two kids who like to play with buttons; I am worried they may accidently retract the slide causing damage to the motor if it gets bound up by the jack stands.
To prevent this mishap, I thought I would pull the fuse for the slide-out motors.
When looking in the fuse panel, it is a 20amp fuse but is a different looking fuse than the other traditional looking fuses. It is a black rectangle box. I am hesitant to tug too hard as I am not sure if these are removeable? Certainly the other traditional fuses are. I presume there is a reason that Jayco opted to not use the typical blade type fuse as the rest of the wiring is using; but not sure what that is.
My description is not very good so I will try and post a picture later this week to show what it looks like.