|
05-19-2017, 04:09 PM
|
#1
|
Senior Member
Join Date: Jun 2016
Location: Seattle
Posts: 115
|
Slideout Question
Hello all,
I have a 2016 X213 and over the last couple of camping trips we have noticed a change with the slide out. In the past, we would slide it out until it "clicked" once and then stop - basically proving it was 100% extended.
Now instead of hearing any clicking, the lighting in the camper fades out. When I release the slide out button the lights are back on. No more clicking, only fading lights to tell me that the slide out is fully extended. The slide out works fine and we have had no other issues with the trailer. Do I need to be concerned about this?
Thanks in advance!
__________________
_______________________________________
2016 Jayco Jayfeather X213
2013 Ford Expedition EL 4X4 w/HD Towing Package
Equal i zer 10k w/sway control
Wife, Kid, Entlebucher
|
|
|
05-19-2017, 04:16 PM
|
#2
|
Senior Member
Join Date: Mar 2015
Location: Sylacauga, AL
Posts: 209
|
Sounds like a low battery issue. Check your voltage. May try plugging in to shore power first or leaving connected to tv.
Sent from my iPhone using Tapatalk
__________________
2016 Jayflight 29 bhds
2015 Ford F-350 SRW
|
|
|
05-19-2017, 04:19 PM
|
#3
|
Senior Member
Join Date: Apr 2017
Location: New Hampshire
Posts: 249
|
Sounds like a battery problem. I would check for loose connections, make sure all the cells are full and terminals are clean.
|
|
|
05-19-2017, 04:25 PM
|
#4
|
Senior Member
Join Date: Jun 2016
Location: Seattle
Posts: 115
|
So even if the trailer is plugged in for days I get the same result. And I always have the trailer plugged in when I use the slideout. Perhaps I need to put a volt meter to the battery and see if something is up. I have a sinking feeling that the battery on this thing is garbage.
If I do end up replacing, can you recommend a battery type and brand? What should I be replacing the battery with?
__________________
_______________________________________
2016 Jayco Jayfeather X213
2013 Ford Expedition EL 4X4 w/HD Towing Package
Equal i zer 10k w/sway control
Wife, Kid, Entlebucher
|
|
|
05-19-2017, 04:37 PM
|
#5
|
Senior Member
Join Date: Aug 2011
Location: Missouri City, The Republic of Texas
Posts: 5,063
|
If you were not connected to shore power at the time then as suggested probably battery is going bad. If you were connected I'd suspect the converter or charging circuit in the power center.
__________________
Cheers,
T_
2013 F-350 CC SB 2WD 6.7PS
2013 Eagle Premier 351 RLTS
-SOLD- 2012 X23B
-SOLD- 2003 Ford Expedition 5.4, Bilstein shocks
|
|
|
05-19-2017, 04:53 PM
|
#6
|
Senior Member
Join Date: May 2014
Location: Calgary
Posts: 113
|
Slideout Question
Ours does the same thing. On shore power it will click but on battery power it just sorta winds down. It's normal.
|
|
|
05-19-2017, 04:58 PM
|
#7
|
Senior Member
Join Date: Jun 2016
Location: Seattle
Posts: 115
|
Except mine also does it when plugged in. Hmmmm
__________________
_______________________________________
2016 Jayco Jayfeather X213
2013 Ford Expedition EL 4X4 w/HD Towing Package
Equal i zer 10k w/sway control
Wife, Kid, Entlebucher
|
|
|
05-23-2017, 04:05 PM
|
#8
|
Senior Member
Join Date: Jun 2016
Location: Seattle
Posts: 115
|
bumping hoping that somebody has advice about what this means when you are actually plugged in... It almost seems like the slideout runs through the battery regardless of if we are plugged into shore power or not
thanks!
__________________
_______________________________________
2016 Jayco Jayfeather X213
2013 Ford Expedition EL 4X4 w/HD Towing Package
Equal i zer 10k w/sway control
Wife, Kid, Entlebucher
|
|
|
05-23-2017, 04:57 PM
|
#9
|
Senior Member
Join Date: Mar 2015
Location: Sylacauga, AL
Posts: 209
|
The slide does run off 12v, but should be running off the converter when plugged in. Have you checked your converter output voltage?
Sent from my iPhone using Tapatalk
__________________
2016 Jayflight 29 bhds
2015 Ford F-350 SRW
|
|
|
05-23-2017, 06:30 PM
|
#10
|
Senior Member
Join Date: Jun 2016
Location: Seattle
Posts: 115
|
No but I will look into that. Thank you!
__________________
_______________________________________
2016 Jayco Jayfeather X213
2013 Ford Expedition EL 4X4 w/HD Towing Package
Equal i zer 10k w/sway control
Wife, Kid, Entlebucher
|
|
|
05-23-2017, 08:51 PM
|
#11
|
Senior Member
Join Date: Mar 2015
Location: Sylacauga, AL
Posts: 209
|
Not sure what your output should be, but I'm sure it should be more than 12 volts in order to charge the battery. Check the specs on your particular model. I have also seen a bad battery cause screwy stuff to happen. Could also be a grounding issue, but I'd start with the simple stuff first. Hope this helps.
Sent from my iPhone using Tapatalk
__________________
2016 Jayflight 29 bhds
2015 Ford F-350 SRW
|
|
|
05-24-2017, 10:20 AM
|
#12
|
Junior Member
Join Date: Apr 2014
Location: Mobile
Posts: 24
|
How do you check the output voltage on your converter?
|
|
|
05-24-2017, 07:47 PM
|
#13
|
Senior Member
Join Date: Mar 2015
Location: Sylacauga, AL
Posts: 209
|
Hopefully someone with more knowledge than I have will chime in. I would check the battery posts when plugged in to shore power.
Sent from my iPhone using Tapatalk
__________________
2016 Jayflight 29 bhds
2015 Ford F-350 SRW
|
|
|
|
Posting Rules
|
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts
HTML code is Off
|
|
|
|
» Recent Threads |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|