Jayco RV Owners Forum
 


Picture 1 of 11 from Album Jayfeather 19H Roof Rebuild
The new "Brite-Ply" EPDM membrane is installed. Next I need to get the front and rear seams patched and closed.
The new "Brite-Ply" EPDM membrane is installed. Next I need to get the front and rear seams patched and closed.
Picture Added 10-01-2014 12:30 PM
Added by Scouter Vic

Showing Picture Comments 1 to 2 of 2
  1. BNear
    10-11-2014 07:33 PM
    BNear
    nice job on the roof. I'm doing the same thing on a kiwi 23b. Quite a bit of work but it'll be nice when it's done. What did you use for additional aluminum supports and for the ceiling covering?
  2. Scouter Vic
    12-19-2014 08:37 AM
    Scouter Vic
    BNear - sorry for the delay, I didn't notice this earlier!

    The aluminum supports are made from cut down 1" x 1" x 8' hollow lengths from Home Depot. Those are attached with angle brackets and screws.

    The ceiling covering (inside) is "puckboard" which is the stuff they use to line hockey rinks. It is also known as HDPE sheets. My wife was pleased with the look of it, and it should outlast the rest of the trailer! A couple of gotchas I'm aware of with HDPE... Cut it with a variable speed jigsaw so it doesn't melt onto the blade, and keep it out sunlight since UV degrades the plastic. Shouldn't be a problem on the interior ceiling - I hope!

All times are GMT -6. The time now is 12:34 PM.


Powered by vBulletin® Version 3.8.8 Beta 1
Copyright ©2000 - 2016, vBulletin Solutions, Inc.
Copyright 2002-2016 Social Knowledge, LLC All Rights Reserved.