Recessed Lighting bulb change in a Eagle Premier

[Gilstandifer]

I have a 2013 Eagle Premier and would like to change the current bulbs over to led's. My question is how do you remove the glass light covers to gain access to the bulb? I would assume the covers have some type of a compression fitting and pull straight down. I attempted to pull/pry them down but feel like I'm going to break the cover. Also, if known, what is the replacement led bulb number? Thanks

[Rob_Fla]

The Glass Lens twists off, turns about a 1/4 turn.

[jdorant]

Twists counter clockwise. It was hard the 1st time, I think because I didn't know what I was doing and now that I know how they come off, its not a problem.

[ragnarm]

On mine it just pulls out, turning does not do anything.

[norty1]

When you re install the glass cover make sure it is tight. I had one fall off and it will break.

[RoyBraddy]

My lens were the dual light fixtures and all you do here is squeeze in near the center and it slides off towards the ends... This is probably a different fixture than you are describing...



Roy Ken