Greetings
I have just acquired a 2009 (i think) 1006 model. It is in excellent condition except the bed slides don't line up properly. I have figured out the King bed sliders are supposed to slide to the drivers side of the double bed sliders. However, it appears that they somehow got bent and their attachment to the bed frames is kinda cobbled up. In the attached picture, I added a support bolt (brass nut as a spacer) to the double bed but that doesn't allow the king slider to pass and the trailer won't close up properly. Are the slides supposed to be even with each other or should one ride higher to allow them to pass?
I also have a bunch of disks (in pic on plywood). Do these figure into the equation at all? Any help would be much appreciated.