Using Renogy with pre wired go power

[Jwiers]

Was looking at adding this kit

https://ca.renogy.com/renogy-200-watt-12-volt-solar-rv-kit/

Can I use and of the pre-wired solar ?

How might I do this?

[russell12839]

not sure of the kit but I installed 2 100 watt panels and an mppt controller on my unit that was wired for gopower and it worked great. They are all basically the same, if you have any questions call Renogy they are very helpful

[RogerR]

I believe the GoPower Wired for Solar is just a pair of wires from a gland on the roof to somewhere in the RV or possibly on the tongue or side. If you can re-route or extend the wires to your MPPT location of choice you will be fine. They are most likely to be #10 wires and more than capable of carrying the 400 watt solar load to the MPPT unless the wires are excessively long.

[Jayhawk 29]

If you can take a look at the underside of your current solar panel , there should be a sticker on it. Check the output. I wired two 200 watt Renogy solar panels with the one Monocrystaline from Gopower. All three are linked to a 30 amp Gopower PWM . You will need a coupler to join the panels together. to just one cable from the roof. While a lot of their kits with the 100 watt panels are cheaper, the additional two takes up more room on the roof and can require a set of extension cables to meet a central coupler to the one cable leading down to your controller.