Awnings & Slides Stopped Working from Control Panel

[videoguy]

We are currently on an all week trip thru Branson MO up thru IL. Both awnings and the 2 lippert slides stopped responding to the switches in the control panel but work fine from the LCI touch panel. Slide 3 still works with the switch and touch control.

I was thinking maybe a fuse but have not found it. The labels in the fuse panel aren’t that helpful. The fuse labeled MON PANEL is fine. Any ideas?

[Grumpy]

Have you pulled the panel to check for a loose wire? The 12v supply to the switches is probably daisy chained.

[videoguy]

Grumpy,

Thanks for your response. We have been on the road and just dropped it off for a couple days while we visit family in IL so I haven’t had a chance to pull the panel.

I did call the dealer while on the road to see if they had an idea/easy fix and they seemed stumped and were going to check with the vendor to see. I mentioned your idea of pulling the panel to check for a loose connection and he thought that was a good idea. Meanwhile he will be checking with the component vendor/supplier.

I will post what I/we eventually find out so that others can use if they run into the same issue.

Thanks again!

[robkelly]

My assumption is also a loose connection somewhere. We had a similar issue, though it was only one slide that didn’t work, and the dealer was able to track down a loose connection somewhere - I searched high and low and couldn’t find the issue.

[Quickst3r]

Curious what the cause was, I too am experiencing same issue with my brand new 34BHOK. It worked at walked through, drove home to show off to family and nothing. Any insight would be appreciated.

[sturgissteele]

Welcome aboard the forums from SW Michigan, Quickst3r.

If the conversation stalls here, just repost your question as a new thread and you'll get replies a little quicker. Happy trails!

[Quickst3r]

Thank you!