On our most recent trip, I noticed the bluetooth control from my phone to the BMPro Node was insanely slow. Connecting takes up to 10-15 seconds (when the screen goes from greyed out to normal). If I attempt to turn on a set of lights, it'll instantly show on my phone that the lights are "ON" and then about 5-10 seconds later, it will update the screen to show they're "OFF". If I wait another 5-10 seconds, more often than not the lights will actually turn on and then my phone will show they're "ON" again.
Everything works immediately when using the touchscreen controller. I'm wondering if I need to reboot the Node and if so, if there is an easy way to do this without disconnecting wires or the battery terminals. I've read cutting the 12v power via the battery disconnect switch does not kill power to the BMPro node - not sure if this is true or not.
My phone is an iPhone 13 Pro Max running whatever the latest IOS is (15.x?)
my phone does the same thing when I first open the app. If I leave the BmPro app open on my phone and not close it... no delay. Iphone 11 and latest Ios
__________________
2022 Jayco Pinnacle 32RLTS, Onan 5500, 380 Watts
Solar, GoPower MPPT, Four 6 Volt batteries, EMS-HW50C, Hughes Hardwired Autoformer
Linear Mode
