Water pump

[Teded]

Water pump won’t turn on. There’s power to the switch, but no power at the pump.
2019 Jayco Greyhawk. Fuse in the panel is good. Are there any other fuses or things I can check?

[Stroked550]

Pull the switch panel and check connections, ours had power to the switch but the pump connection had come loose

[Teded]

Checked that , power to the switch good.
Fuse good, can’t figure it out.

[RogerR]

Any chance the connections at the pump. Either pump to ground or the hot wire are bad? You can test with a multimeter at the connections. Jayco crimp connections or notoriously bad. Don't trust the ground either as they have failed or were simply never tightened properly.

Or you got a bad pump motor. Before i bought one I would run a wire to the battery and try wiring it direct.

[Spower]

Yup check all wires! I had the same issue and it was wire that somehow came loose and detached itself!

[JimD]

I had the switch fail inside the pump. Easy repair or you just replace the pump. See the following thread.

https://www.jaycoowners.com/forums/f...0-a-91737.html

[TWP723]

Considering what you've checked already, I'd say it's the pump.

[Stainless]

"No power at the pump" So I assume you used meter to check wires at pump end. Did you confirm there is a good ground at pump end also?
Can't accurately check for power without a known good ground.