Lippert Ground Control 3

[SlingShot]

I was having problems with my 2017 Seismic 355W failing to auto level inside a shop on a concrete floor. I want to share what I found in order to save others some headaches. I was in a time crunch when I picked it up from the dealer and knew this was an issue I would need to address when time permitted. It would not auto level in the dealers shop during the inspection. Long story short... four of the six jack legs were connected to the wrong ports on the controller. Auto level was impossible. It was basically fighting itself to try and find level, and twisting the trailer in the process. After pulling off a few panels and locating the controller I was able to confirm what I suspected was wrong.




After connecting the legs to the correct ports, auto-level works every time.


My controller was located on the door side, inside the front of the basement storage area where the factory spare tire crank is mounted.


Sent from my iPad using Tapatalk

[apgambino]

Interesting....i have a 17 355w and bemoan the autoleveling system from Lippert. Mine will autolevel, but it's a crapshoot. Sometimes it will level where I park it next to the house sometimes it won't.

Did your system ever work before you opened it up? During the leveling process my system tells me which Jack it is using and it matches my screen.

Sent from my SM-G935V using Tapatalk

[SlingShot]

When in manual mode, if I held down rear and left, the rear right jack would operate. Autolevel always failed. Always had an out of stroke, or similar errors. Works great now.