I have purchased the Furrion FCKIT30-ps. I would like to install it this weekend but Iím concerned the supplied gasket wonít seal well on my 287 slx aluminum siding. Is there a putty or tape that I should use to guarantee there are no leaks?
X2 on the butyl tape - worked great when I did my Marinco conversion. The old mouse hole came from the factory with the butyl tape too. You can use some Dicor No-Sag lap sealant too but I found that once I tightened the new ring in place the butyl tape spread out and filled in nicely so I didn't need it.
TT: 2015 Jay Flight SLX 195RB Baja Edition
TV: 2014 RAM 1500 Big Horn CC, 5.7L Hemi, 8-spd, 3.21LSD, Factory Air Ride/Tow Pkg, Andersen WD/SC
The receptacle was considerably smaller than the hole so I had to make a reducer with aluminum to cover, took an extra couple of hours. By the time I was done I was pretty disappointed how crappy it looked.
So guess what, I ended up buying the whole Marinco kit again, wasted money the first try but lesson learned.