Haloview RD7 Max

[AndyO]

https://www.haloview.com/haloview-7-720p-wireless-range-dominator-system-rd7-max.html

I installed the Haloview RD7 Max today. I went the simple route first, just installing and powering the cameras to make sure they all work. I still need to complete the wiring by finding and tapping into the trigger wires. I'm not a big fan of having the cable from the camera to the booster there, but it works, and for now I'm leaving the booster at the rear of the roof. The kit comes with 36' of cable to use if needed.

[AlS]

I have a 2018 Pinnicle 36SSWS and have installed the side-cameras at the forward-most positions for the running lights. The lights for the side-markers work but I cannot get anything from the cameras.


Anyone happen to know if the power is adequate to power both the lights and the camera? Or what my problem might be?

[AndyO]

If you tapped into the correct wire, power shouldn't be the issue. Did you pair each camera, following the instructions? I have still not been able to get the side cameras to work when I turn on either turn signal, but otherwise they work fine.