making dinette into bed

[vonm]

We have a 2015 Whitehawk 23MBH and are having trouble converting the
dinette into a bed. We have tried placing the cushions everyway possible & they just don't cover the table completely. Also, when you do lay down on it the cushions start moving and then fall off. We've tried putting a fitted sheet
on it to try and keep the cushions in place, but no luck. Any one know the secret to doing this or have any suggestions?

[rjackson]

you could try laying some of the rubber drawer liner on the table, and cut a piece off pool noodle to take up the gap between the cushions

[Vaneta]

I had the same issue with my Whitehawk 21 FBS and finally started googling it and others had the same issue. I finally got my cushions to fill all of the spaces but just like you, they moved around. I actually wanted to make a "twin" size bed at the window end of it so I cut a board to bridge the gap. The board fits under my seat cushion when not in use. I use some of the cushions and a piece of memory foam as my mattress. Though it's not roomy, I can still use the ends of the bench for sitting and I use a smaller table. So the "twin bed" can stay down and we can still have some space on the ends to use as a table/seating. Hard to explain....

[Murff]

When we make our 20MRB dinette to a bed, the cushions get a fitted sheet over them and that is covered with memory foam with a sheet on it.

When not in use, the memory foam goes on the Murphy bed which is also not in use.

Murff