2018 whitehawk 29bh ems install

[Kyleorsini]

So finally first weekend camping In the new trailer at our seasonal site. Getting everything set up currently.

I’ve got a progressive hw50c ems and looking where I’d find the transfer box for a hardwire install.

[Sundancer330]

Lots of how to videos on Youtube. Since every trailer will mount in different places you will have to decide where it best fits your trailer. I followed the cord from where it enters the trailer and found the best location to be under the bed for easy access, cut the cable and mounted the box in less than 30 minutes.

[Kyleorsini]

I’m more asking where it would be I can’t see it behind any access panels, only can see the fuse panel

[Kyleorsini]

I’ve pulled the breaker panel out a bit and can see the wire I want to use to go into the ems, however I don’t see a transfer switch it goes into the panel and then down into the floor. Aswell as a neat
Of other wires. Then I’m assuming it’ll be ran under the trailer to the rear corner at the shore power connector.

Could be under the trailer requiring me to remove some of the belly?

[Sundancer330]

Not sure what you mean by transfer switch. All you will do is cut the power cable at any point along it route, then install the EMS between where you cut the cable, one side in one out. I have no idea if the cable goes down into the underbelly, mine comes in the back corner into a make shift box area where the cable is stored, from there mine travels across the floor under the bed to the power supply. Do you have a storage area near where the cable enters your trailer, if so maybe remove a panel to see if the cable is in there