BMPRO node terminal connections

[ARoamer]

Looking at my bmpro node for proper wire connections due to a dinette light fault. Some terminals are the spade type and others have a small white clip that I assume locks the connection. I can't get a good view of that connector type the way the node is mounted. I poked around carefully with a small screwdriver trying to get it to release with no sucess. How do I get the wire to release from that type of connector?
TIA!

[Learjet]

with out a picture...either lift the leaver or if it's a small square with a cross...press it in with a screw driver and while holding it pressed in with the screw driver pull out wire.

Mine has levers or the release buttons.

[ARoamer]

2 pronged plastic tab.
I think the hole above may be for a test probe, or to release the wire, not sure. I pushed quite hard and there was no give.
Push the plastic tab to release?

[Learjet]

yes, push and hold the white square button in with a screw drive then pull on wire.

[ARoamer]

Got it, thanks. My node is mounted so poorly, only 2 screws, I nearly broke it off the wood mounting frame pushing on the plastic wire release tabs.There were 6 or so wire strands that weren't in the connector. Dosen't seem like that would give it a fault, but it hasn't faulted since.