Furrion Fireplace Error Code

[Charger060]

Please forgive me if there is a similar post, I was not able to find one. We Purchased an '18 Pinnacle 36KPTS last Sept, used it only a couple of days before winterizing in October. Here in the Northeast its a little on the cold side, getting ready to go out the first week of April. I turned on the fireplace (Furrion FF405S15A-BL), never turned on before, ran for a couple of minutes with heat on, then went to an error code 88, "Manual reset overheat protection has triggered". Anyone have any ideas??? I was thinking maybe the motherboard may be defective. How do you remove the fireplace ??? Any help would be greatly appreciated. Thanks.

[Sundancer330]

That manual isn't to helpful, code 88 says Inspect the fireplace and check
that the air inlets and outlets are
not blocked as this may cause
overheating.

[Charger060]

Amen Sundancer

[torilynn79]

This same thing just happened to me. Do you know how to reset the fireplace to get rid of the error code?

[Charger060]

All that I did was cut the power (turned off breaker) while fireplace was on, this seemed to clear the error code and reset the unit

[CJ68]

I am also having a problem with my Fireplace. A few seconds after I turn it on I don’t see an error code but a red light starts blinking, then the heat goes off, and a few seconds later the blower shuts down. I cleanse the air inlets and outlets with the vacuum, and tried resetting by turning off the circuit breaker. No luck. The heat continues to shut off a few seconds after I turn the unit on. I also checked to make sure I had the temperature turned up. Anybody got any other ideas . Thanks