Where do you keep your sewer hose?

[2nOZ]

We keep two 10’ sections in the rear bumper and the 90 degree elbows in a covered plastic tub in the basement.

[01tundra]

D&W Super Slider sewer hose tube. Stores our Rhinoflex hose with the elbow attached.

https://www.dwincorp.com/product/sup...le-super-tube/

[sragan]

I store 2 - 10 ft lengths in my bumper and the 90 fits just fine but snug. Since I have trouble getting the cap off at times I have a short string looped over the 90 and run through the hole in the cap. This allows me to tug on the string loop pulling the cap off and pulling the hose out.

[Atlee]

Store it, plus a 10' extension, in a 35 gal Sterilite tub which I store in the large curb side exterior storage compartment. Before I got this 23RB, I used to keep it in the bed of the pickup.

I keep all other equipment I need, or may need, in the same tub.

[edatlanta]

Mine is used 24/7/365 so storage isn't a concern. When I move campgrounds I just lay the hose/fittings in the bed of my truck. A good airing out doesn't hurt a thing IMHO.

[scottraycraft]

was storing in bumper
but on of those crappy end caps popped off...didn't lose the hose thankfully but need new end cap or a different storage spot

even in tubs I don't like storing poop tubes in my camper bin

[TCNashville]

I keep a RhinoFlex 15' & 5' extension in the bumper. To keep the bumper caps from going bye-bye I drilled 2 small holes top & bottom and use a stainless steel spring to hold them on. As you can see I used to tape them down.

[shrpshtr]

Rear bumper. Goes straight from there to the hookup and back. It's always there and ready when needed. I've thought about the cap coming off but mine are still very snug. If they get noticeably looser, I'll install a tether from the bumper to the cap to prevent losing it.

shrp

[BJR]

We lost a cap a couple of trips ago. I got the Camco pinch ones and they're noticeably better...they're almost difficult to remove.

Accessories (orange adapter and clear elbow) go in a bag in a clear bin.

Some day we'll do the fence post mod.

[Marine71-76]

Small one with two different elbows are stored in the side sewer compartment. Installed long tube under the body for 2 longer hoses. Once we needed close to 85' of hose. We also have a container for the two slinky items we have.

[GrumpyDad]

Well, everyone was right, the Rhino Extreme hose I bought does fit int eh bumper just fine. made the mistake of jamming the clear elbow in too, which made getting it out a pain. Had to ram a 2x4 in from the other end to get that out. Will keep the clear elbow and other adapters in a spot in my storage area, right beside the rubber gloves I wear for dirty jobs.

[jlechmanik]

We have endcaps on our hoses. Rinse them with water after dumping, then collapse them and cap them. Then they go in a nylon bag (from Camping World).

[A Savage Adventure]

I have a snap-shut tote that I store the sewer hose, parts for it and the leveling ramp. Inside it doe start to get a bit musty. I often hit it with some Lysol in between sites.