The fridge in our 19h works when it wants to which usually does not coincide with when we need it so I am replaceing it with a residential unit that has a larger interior space but slightly smaller exterior dimensions. I've started to take the factory unit out by removing the screws on the front of the unit but am having difficulty locating any screws on the outside/back. Does anybody know for sure where all the retaining screws are for one of these?
Buddy of mine last year did exactly what you are doing. He just had a few screws in front that held the frig in place. All we did was disconnect the gas line, and power. Then we were able to slide it forwards. We placed a couple milk crates on the floor in front of the frig. So we could set it on to regrip.
It's a dometic and I removed the screws on the front but it seems like something is still holding it in place. I saw on one unit, looked much older, that they may be two in the rear. Hopefully I can locate them. You'd think it would be fairly easy.
It's a dometic and I removed the screws on the front but it seems like something is still holding it in place. I saw on one unit, looked much older, that they may be two in the rear. Hopefully I can locate them. You'd think it would be fairly easy.
It's is a Domestic, what model #? The installation/owner manual can be found online, and it will show exactly where each mounting screw/bolt is located.
It's is a Domestic, what model #? The installation/owner manual can be found online, and it will show exactly where each mounting screw/bolt is located.
I'll have to look the model up but will check online. Thanks!