X19 Bed

[MrKong]

I bought a new 11 X19. I was getting it ready to go in a couple week and I noticed something odd. The mattress on the tongue side is a little too long. I have it pushed out to the end, but it still sticks out over the edge enough that it pushes the table back cushion forward about two and a half inches. If you are sitting at the table, you need to raise the mattress up or you will be leaning forward. If I push the mattress back farther, it will pushing on the canvas.

My old one was not like this. Do you think I should call Jayco and ask about it?

[Phar0e]

Do you have two bunks? Is it possible the mattresses got switched. Sometimes one bed is a queen and one a double. Just something to check.

[go wild]

You could try swapping the front and back mattresses to see if that makes any difference.

[tlhdoc]

The mattresses on my 17Z are two different sizes. The front is a true queen and the back is 2 inches narrower. I would measure the mattresses and see if they are the same size. Good luck.

[chillywilly]

You know, I have the same trailer and now that I think about it mine is the same. Guess we never worried about it before.

[MrKong]

I'll check it out when I have the ends down again. The back mattress fits perfectly, so I doubt that it would change much, but I will see. Its been raining so much, I hate to put the ends out here at the house. I hope we some some nice weather this week, and I can get it done.