|
X23B back bunk TV mount
Hey guys, I have been wanting to put a TV in the back bunk end for my son and finally decided to give it a shot. I used a scrap piece of oak I had in the shop and used it to make a back board to span from floor to ceiling as there were not studs in the wall where I wanted to put it. I used a pocket hole jig to put the screws into the studs on the floor and ceiling. I was going to use a hinged TV mount but didn't think there would be enough room for the TV to stay on the wall when the bunk end is closed for travel. We have the hypervent material installed under the mattress too so that doesn't help. I decided to order the same TV mount that came on our camper for mounting an outside TV. I figured this would make more sense since we needed a quick release option and this would allow us to use the TV outside if we wanted to also. I am still trying to find the correct shade of stain, but you guys get the idea. I hope this helps if anyone was looking to do this!
|
Linear Mode
