x23F bed not level

[Hartos]

I am not sure what caused it but it seems that suddenly one of the beds is not dropping down level and slopes noticeably away from the trailer. Maybe half bubble off level.

Is there any sort of adjustment on the cable assembly on either side? i see they attach to the middle of three holes on the mounting bracket at the trailer end but that seems too much for the amount I need to adjust.

Thanks!

[Jagiven]

Welcome aboard!

First thing do not use the bed until you do some investigating. This is not a normal issue.

What year is you htt? There have been a few changes over the years.

My guess you have a structural issue. The cables are mounted on both ends. The upper end of the cable the mount is very visible. I suspect this is not your issue.

I recommend checking the fasteners on the bunk frame. I have thee on the inside, at least one on the outside the secure the cable. There might be two other screws.

Make sure they are all right, and nothing is pulling apart.

[Hartos]

2015 x23F... i will do some checking, i don't see any obvious issues with bunk side but will check further.