Jayco RV Owners Forum
 


Reply
 
Thread Tools Display Modes
 
Old 06-26-2011, 05:25 PM   #51
Senior Member
 
Join Date: Oct 2009
Location: Calgary
Posts: 518
I just brought my 5th wheel home from the farm to clean, wax, and get ready for my next trip. The first thing I did when I got home was to check my AC bolts, but mine were fine.
__________________

__________________
2007 Jayco Eagle 325BHS
2010 Dodge 3500 Laramie
Kipor 2000 Generator
Albertaguy is offline   Reply With Quote
Old 06-26-2011, 05:48 PM   #52
Senior Member
 
nylyon's Avatar
 
Join Date: Apr 2011
Location: Southeast, NY
Posts: 960
Check your sinks too. 2 nuts holding my kitchen sink were completely off, and the rest were loose.
__________________

__________________
Karl - Southeast, NY
2011 Jayco Super Lite 30.5 BHLT
2003 Ford F250 Lariat 6.0 PowerStroke Turbo Diesel My mods Bathroom Door Water Filter TV mount Cork Board
Streamline your A/C
nylyon is offline   Reply With Quote
Old 06-27-2011, 08:13 AM   #53
Senior Member
 
Join Date: Oct 2009
Location: Calgary
Posts: 518
Quote:
Originally Posted by nylyon View Post
Check your sinks too. 2 nuts holding my kitchen sink were completely off, and the rest were loose.
I will do that, thanks!!!
__________________
2007 Jayco Eagle 325BHS
2010 Dodge 3500 Laramie
Kipor 2000 Generator
Albertaguy is offline   Reply With Quote
Old 06-30-2011, 06:11 PM   #54
Senior Member
 
RVhiker's Avatar
 
Join Date: Dec 2010
Posts: 1,253
I think there are two issues with the 4 hold down bolts on AC's.
1) Perhaps they loosen over time as the gasket compresses. I would caution that it is very easy to tighten these bolts, even when they are tight enough, as the gasket is spongy and easy to compress. Be easy.
2) Sloppy assembly at the factory - or perhaps some QC personnel think that two bolts tightened properly are OK if they are diagonally opposite one another.

With respect to apparent sloppy assembly at the factory, this thread lists new or almost new Jayco's with this issue: 2011 Starcraft, 2011 30.5BHLT, 2011 26BH, 2010 365BHS, 2011 New Jayco (unspecified), 2011 28.5RLS, 2011 33RLDS, 2011 26BH, 2011 26RLS.

I finally got a response from Jayco customer service, after two contacts from me. Here's my question and the response. This was my second contact, and I had replied to the confirmation e-mail I got from Jayco (but had not got an answer to):
---------------------------------------------------------------------------------
My question: So far, I have not received a reply. My question had to do with the four mounting bolts that hold the AC to the roof of my 2011 Eagle Superlite 28.5RLS trailer. Two of the bolts were completely loose, not even touching the flange that they tighten against. The dealer corrected this -after I reported it to them upon learning of the problem in this thread: https://www.jaycoowners.com/showthread.php?t=2880. But why was the AC installed like this in the first place?

The Jayco response: Thank you for taking the time to contact us here at Jayco. I'm sorry to hear your A/C bolts were loose. There was an issue a couple of years ago in the Jay Feather product. There is no issue in regards to the Eagle series. Basically this was simply an isolated issue of production error. We build these units with human hands and inspect them with human eyes. We certainly do make mistakes. We are not perfect. This is why we have the 2 year warranty in place so such issues can be taken care of by Jayco after the unit is owned.
Thanks again for contacting us and I wish you many years of trouble free camping.
------------------------------------------------------------------------------------
From the reports in this thread, I don't think they've got the original problem fixed.
__________________
There's lots of advice and information in forums... sometimes it is correct. For example, all of my posts are made by a political appointee who got the job as a reward for contributions to my diesel bill.

2011 Jayco 28.5RLS; 2008 Chevy Duramax; Pullrite Superglide Hitch

RVhiker is offline   Reply With Quote
Old 07-06-2011, 08:43 PM   #55
Member
 
scalemaster's Avatar
 
Join Date: Nov 2010
Location: Nova Scotia
Posts: 34
I checked mine. Three bolts OK, one threaded out 1 inch. No signs of leaks, will check yearly from now on.
__________________
2007 Jayflight 25RKS- SOLD
2011 Jayflight G2 31 RKS with aluminum wheels- SOLD
2004 Silverado 5.3L with Hypertech and Borla exhaust-SOLD
2011 Silverado LTZ 6.2L Max Tow Package
scalemaster is offline   Reply With Quote
Old 07-28-2011, 06:56 PM   #56
Senior Member
 
NACSKINS's Avatar
 
Join Date: Apr 2011
Location: Schertz TEXAS
Posts: 154
checked mine and all 4 were a little loose. Snugged them all up a bit. Adding to maintenance spreadsheet. Maybe a little loctite.
__________________
2011 Jayco Jay Flight Swift 264BH
2008 XLT SCab 5.4L, FF, 4X4, 3.55 LS, Gotts Mod w/Drop in K&N, Holley Hooker Aerochamber Muffler, Edge Evolution, Tekonsha P-3 Trailer Brake Controller,33.5" Nitto Terra Grapplers.
NACSKINS is offline   Reply With Quote
Old 07-29-2011, 09:14 AM   #57
Senior Member
 
Seann45's Avatar
 
Join Date: Jun 2010
Location: Saskatoon Sask Canada
Posts: 9,701
Quote:
Originally Posted by NACSKINS View Post
checked mine and all 4 were a little loose. Snugged them all up a bit. Adding to maintenance spreadsheet. Maybe a little loctite.
I am not sure about using loctite. much of the loosening can be from the gasket getting compressed loctite will just make it harder to tighten them down again....
__________________
Seann
2004 Chev Silverado Duramax optioned past the max. 2009 Jayco Eagle 308 RLS 765 watts of solar, 6-6 volt batteries (696 amp hour), 2000 watt (4000 surge) whole house inverter.
175 days boondocking in 2017
215/2016, 211/2015, 196/14, 247/13, 193/12

Seann45 is offline   Reply With Quote
Old 07-29-2011, 12:02 PM   #58
Junior Member
 
Join Date: Nov 2010
Location: Alberta, Canada
Posts: 6
I checked mine on my 2010 23K a couple weeks back. One was very loose, two were finger tight, and the other was tight. I can see how the gasket would compress over time, especially by the material its composed off (just looks like spray foam to me). Something to check on a regular basis.

Thanks all for the heads up on this.
__________________
2010 Jayco 23K
bordercity is offline   Reply With Quote
Old 07-29-2011, 06:27 PM   #59
Senior Member
 
NACSKINS's Avatar
 
Join Date: Apr 2011
Location: Schertz TEXAS
Posts: 154
Quote:
Originally Posted by Seann45 View Post
I am not sure about using loctite. much of the loosening can be from the gasket getting compressed loctite will just make it harder to tighten them down again....

Good point, Thanks.
__________________
2011 Jayco Jay Flight Swift 264BH
2008 XLT SCab 5.4L, FF, 4X4, 3.55 LS, Gotts Mod w/Drop in K&N, Holley Hooker Aerochamber Muffler, Edge Evolution, Tekonsha P-3 Trailer Brake Controller,33.5" Nitto Terra Grapplers.
NACSKINS is offline   Reply With Quote
Old 08-02-2011, 09:46 PM   #60
Junior Member
 
Join Date: Jul 2011
Location: San Diego
Posts: 5
I started a new thread on this subject and the moderator closed it and pointed me here so I thought I'd just add my comments into this thread (below). I read through all of this thread and I guess my original hope was that Jayco reps monitor the forums. From the sounds of the posts and the lack of a Jayco response, I guess that isn't the case. Too bad, they could lear a lot from their customers...

I'm new to the forum but have owned our 2010 19H HTT for almost two years now. On another RV forum I came across a thread talking about loose A/C mounting bolts. I opened up the cover on the inside of our A/C unit and found all four bolts loose with two of them backed out to the point where they were touching the plastic housing.

I did a few searches and there are a number of threads on that forum about this problem and at least a dozen people have found the same thing. I don't live close to my Jayco dealer so I thought I would post the questions here.

What's with the loose bolts? once they have been as loose as mine got, has my roof seal been compromised? As I mentioned, it is a long way to my dealer so I'd like to know what I am supposed to do (I have applied blue lok-tite and tightened the bolts to a snug condition).
__________________

Larry2C is offline   Reply With Quote
Reply

Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Trackbacks are Off
Pingbacks are Off
Refbacks are Off


» Virginia State Campgrounds

Reviews provided by

Powered by vBadvanced CMPS v3.2.3

All times are GMT -6. The time now is 12:44 AM.


Powered by vBulletin® Version 3.8.8 Beta 1
Copyright ©2000 - 2017, vBulletin Solutions, Inc.
Copyright 2002-2016 Social Knowledge, LLC All Rights Reserved.