Secondary slide seal replacement source

[mikefos]

Howdy,
I need to replace at least one secondary slide seal on my rig. This is the outside bulb seal that seals the outside of the slide to the wall of the camper when the slide is in. It sits in a slot. I think the correct one is in the link below but am not sure. Anybody order one of these and have a source?

https://www.amazon.com/AP-Products-0.../dp/B00EZX0E7M

Thanks,
Mike

[norty1]

That looks like the same one I ordered thru my dealer from Jayco. Mine was worn on either end from wear and tear. I saved the old one and cut the damaged ends off and used it on a shorter run.

[RedHorse1]

I bought a coil of seal similar to your pic. I needed a wider flat flange tho, what you show would not work for me. I’d suggest pulling a section loose and take measurements. I cut a short piece (was coming apart anyway) and took it to a local RV repair/resale place here in Houston (PPL). The counter guy pulled out a catalog and helped me find a match. Had to buy the whole coil at $100 for 50’ IIRC. With some measurements etrailer.com might be a good source. Get the diameter of the round part and width of the mounting flange.

[Topperace]

I ordered the secondary seal from Amazon, the same as in your link....replaced a damaged one on one of our slides...easy to install and works fine...