2019 Seneca

[Roll'n Olaf]

Hello, I just purchased an aftermarket GPS system and I want to program it correctly. I was wondering if anyone out there actually measured the full height including roof air conditioners, etc? I'm guessing the width would be what Jayco posts.
Thank you for your help, Tony

[SloPoke]

Unless you have access to a truck-height measuring stick... it is more than a two person job.

Drive your seneca to a flat parking spot... you have to flex your suspension by driving it... you can't just go lowering it from the levelers and get an accurate reading.

Take a 6-foot straight edge and a level (better a 6-foot level_ and set it on top of the Satellite dish (ours is the highest point) make sure it is level and measure the bottom of the level to the ground (second person)

The first time we measured, we were wrong because we just dropped the rig off the jacks...

[Roll'n Olaf]

Thank you for your advice. I was hoping for an easy way out and someone who measured theirs because I just spent a few days in the hospital and ladders are not ok at this time.

[RVermont]

Originally Posted by Roll'n Olaf

Thank you for your advice. I was hoping for an easy way out and someone who measured theirs because I just spent a few days in the hospital and ladders are not ok at this time.

I never measured mine but it is listed at 13' 1" I use 13'6" for looking at clearances. 2018 ts. I have been under two bridges claiming 13'4. But these were in NY. Where they sometimes understate by 6-12 inches.

[EA37TS]

I checked the height on both the Seneca and the Entegra Accolade on the web. The Seneca is not listed but the 2020 Accolade says 13'4" with AC and satellite.

I would imagine the Seneca is basically the same as the Accolade.

[Mark S]

Most states have a maximum vehicle height of 13’6”. I use that number to be safe.