2021 Seneca Brake and Turn Combined?

[ebarchak]

I am new to the group. I have been reading quite a bit on this forum and learning a ton. You guys are wealth of knowledge.

I am picking up my 2021 Seneca 37TS in a couple of weeks. I am getting my Ram 1500 prepped for flat tow. I have ordered a Roadmaster Nighthawk, Roadmaster Direct-Connect Base Plate Kit, Roadmaster Battery Charge Line Kit, RoadMaster 6-Wire Trailer Connector, Roadmaster Bent Electrical Socket Bracket, Roadmaster Universal Hy-Power Diode Wiring Kit, 503 - M&G Brake Cylinder, MG-Kit - Air Brake Coach M&G Installation Kit, and the 10-139 - M&G Breakaway Kit.

I am trying to determine the required parts for the brake and turn lights to function correctly with the diode wiring kit. Are the brake lights and turn signals on the Seneca combined or seperate? My guess is 2018 to 2021 are the same set-up. According to the wiring diagram, if the Seneca lights are seperate I need a Bright Light Converter RM-732. If they are combined I am good with what I have already ordered.

Is there anything else I will need to complete the flat tow install?

Thanks,
Ed

[EA37TS]

Welcome to the forum

Same pin on the 7 pin connector for turn and brake. One pin for Left and one pin for right.