Adjusting The Hot Water Heater Facade Panel
On my on-demand heater, the panel that surrounds it is (see sketch) 1) front cocked out over-hanging the generator panel (by maybe 1/4-3/8") -Basically reverse from how all the other panels are, where the trailing edge of the forward one over-hangs in-front of the next one like a shingle. 2) not seated well into the rear-end cap causing a 1/8-1/4" gap at the very bottom decreasing as it gets closer to the top
Has anyone ever adjusted this panel, if so, how do you get to the top-portion? I'm worried that if I let this go, it could cause issues with the rear cap.
__________________
'14 Jayco Seneca 37fs
20' Look Enclosed Trailer
|