Backup camera no signal

[ncgreyhawkmv]

Have a new greyhawk mv. Backup camera worked for a short time and then showed "no signal" Took back to dealer 115 mi. 1 way. told me backup camera was not wired right and needed to be replaced. They said it had some "bent pins" Jayco sent me a new camera. They were very helpful. Installed new camera. Still shows no signal on dash display. Called Jayco. They said there is a cable connection under the bed. Couldn't locate it. Any thoughts or suggestions would be appreciated. Scheduled to have a local dealer look at it in Nov. thanks,

[Hivoltage98]

Check to see if the camera has 12 volts. Check all fuses.



Sent from my iPhone using Tapatalk

[ncgreyhawkmv]

Thanks, do you know what number or circuit the camera is tied to? The brake light is coming on. There were only 2 wires to tie into and they both seem to be connected ok.

[snowbird47]

May or may not be related, but my 2012 Greyhawk had this problem twice. For me it turns out there is an in-line fuse in a rats-nest under the dash that powered the camera and in my case also the power side mirrors. I had to pay a tech the first time it happened to find the fuse, but after that he marked it well and the second time I changed it myself.

[ncgreyhawkmv]

Thank you, we are camping this weekend in s. Carolina and I will have a chance to check this out. Let you know what I find.

[ncgreyhawkmv]

Checked all fuses and circuit breakers. All good, still shows "no signal". Does anyone know if there is any type of reset or connection behind the dash?