I have a 2007 Melbourne that has this Voyager rear camera and monitor. Screen comes on but can’t see anything. There are 4 wires going into the camera (So is this a 4 pin camera?) Could I purchase a new 4 pin camera and splice it to the wires already ran rather than trying to run new wire?
Hi, first of all you'll need to make sure those wires are good and not broken beyond the camera. The four wires at the camera should be (1) ground (2) power (3) ground (4) video. You would need to be familiar with a volt meter and be able to disconnect the wires from both ends to test them unless you had a video source. If you get a new camera you'll need to match the wires up correctly. Shouldn't be hard to do since two are grounds and one is power. The remaining wire would be video and it's usually shielded. Good luck.