Bedroom slide front motors inop

[Dave_Jan]

Seneca 37fs bedroom slide front slide motors do not have power fuses are good. Slide is out about three inches. Need to know how to free slide motors so I can push slide in.

[Dave_Jan]

Originally Posted by Dave_Jan

Seneca 37fs bedroom slide front slide motors do not have power fuses are good. Slide is out about three inches. Need to know how to free slide motors so I can push slide in.

BTW. We are stuck in Avon OH

[Dave_Jan]

Originally Posted by Dave_Jan

BTW. We are stuck in Avon OH

Does anyone know where the control box is for the Schwintek slide Seneca 37FS

[ed4ster]

Dave, here is a link showing where ours is located on our 2016 37FS. https://www.jaycoowners.com/forums/f...ion-46079.html Also you will find a Schwintek trouble shooting guide.

good luck, and let us know how it goes.

ed

[Dave_Jan]

Originally Posted by ed4ster

Dave, here is a link showing where ours is located on our 2016 37FS. https://www.jaycoowners.com/forums/f...ion-46079.html Also you will find a Schwintek trouble shooting guide.



good luck, and let us know how it goes.



ed

Thanks Ed. I had looked at that post and found the controller. The code it is giving is a short in motor 2. Two green flashes followed by8 red flashes. At a loss at this moment.

[norty1]

Last problem I had on my br slide was a small connector at the inside on the bottom of the slide got wrapped in something and unplugged itself.

It may be a simple fix if you can access it.

[javamon]

See attached, starting on page 11 - error codes (if you can get to your controller and how to disengage motors). It's unforgivable where Jayco placed the controller - under your bed which cannot be lifted unless the slide is out. Your scenario is the very reason I modified my controllers so I can access them thru a service panel from the outside bed frame. Good luck and please let us know how it turns out.


https://www.jaycoowners.com/forums/f...m-64994-2.html


Post #11

[javamon]

Start on page 11.

[javamon]

https://www.youtube.com/watch?v=xojUdPDWNS0

Explains how to read controller codes, how to override controller and how to manually retract slide by disengaging motors.