Generator switch inside coach

[bdoc51]

In need of some help or suggestions! I have a 2016 Jayco Redhawk 31XL with an Oman generator. Inside, it has the normal GenSet starter which has worked perfectly until I decide to take a trip from Texas to Florida. Now, the prime/start is failing to work, but I can push start and the generator starts, but I can’t kill it unless I do it on the generator. Both functions work on the generator on the outside. I have made sure I have reset that breaker on the generator itself . Any help I could get would be appreciated!! Could it just be a fuse that’s blown and where would that be??

[Grumpy]

Probably a loose connection, check the back of the switch panel.

[fast_st]

Yes, there is one wire that's the kill, normally grounding out the low voltage side of the ignition, pull the switch panel and see if there is anything unplugged on the switch part then you can test the wire from the switch panel to the generator. When the switch on the engine is grounded (stop) you should see the ground show up on the panel as well as they're all just in parallel.

[glamisbound]

Yup, either a wire issue or the switch itself.