Jacks

[Gmward69]

Hi. I have a 2013 Jayco Melbourne 28f. The jack panel continuously beeps when ignition is on. This just occurred after jacks were lifted up. Now jacks won't go back down but makes the sound like it is doing something when buttons are pressed on the jack panel. Jacks are currently up at this time. Any suggestions as to why panel keeps beeping and why jacks now won't go back down. I thank you for your knowledge.

[ChristopherW]

Telling us what type of jacks you have would help in trouble shooting. Here are some notes I have from my Big Foot Leveler Jacks.

-Alarm sounding at engine start may mean a jack is partially down. Push RETRACT all.

-Alarm sounding while traveling means a jack has slipped down a little i.e. 1/2”, usually due to a bumpy road. Stop, turn off engine and push RETRACT all.

-L & R Lights on = System has Timed out, Power on System.

-All up flashing or Air Dump flashing = Communication Error on panel or sensor board. Red wire to sensor bad or power is lost. Unscrew panel,

disconnect red wire and reconnect in 2 minutes.

-Occasionally manually raise Rear all the way up, let rest for 10 min. Repeat for the Front. This purges air in pump from never extending jacks all

the way out.

-The below pic is from another post in this forum of a user adding small rubber plugs from an auto store to depress the “jack position sensor”. When this foot drops a little or does not fully retract it causes the alarm to sound (as mentioned above).

I hope this helps

[Gmward69]

Thank you