Roof marker lights

[Chuckmaki]

One of my Marker lights on exterior of overhead bunk is broke does anyone the size mounted hole. I’m looking at 3/4 inch bullet style thinking about ordering to replace it

[16WhiteColly]

Check etrailer for a replacement or ebay/amazon, you can find a match.

[RogerR]

Post your year, brand and model trailer and a picture for best results if you don't see one on Amazon or Etrailer.

Usually 2 wires with crimp connectors. I like the low temp solder joints that come in shrink tube for replacement connectors. The Jayco crimp connectors can corrode or come loose.

[16WhiteColly]

The entire 12V wiring system on Jayco trailers are put together with Scotch Lock connectors which are junk.

[Jmahovsky]

I contacted Jayco Parts (Parts@jayco.com)and they sent me the part number (0272743 : LIGHT,CL AMB TEAR DRP LED W/BLK BASE W/FM GSKT) then I called a Jayco dealer and their parts department ordered it and had it drop shipped to my house. I think it was less than $15.

[wmurphy]

I replaced all of the front clearance lights after a couple had cracked/broken lenses. I found these on Amazon and the fit perfectly. They are much brighter than the stock lights and have held up well. I also used them on my UTV as turn front turn signals with no issues. Way cheaper than OEM. $10.95 for ten.

https://www.amazon.com/gp/product/B0...?ie=UTF8&psc=1

[AKRUEBBE]

Originally Posted by wmurphy

I replaced all of the front clearance lights after a couple had cracked/broken lenses. I found these on Amazon and the fit perfectly. They are much brighter than the stock lights and have held up well. I also used them on my UTV as turn front turn signals with no issues. Way cheaper than OEM. $10.95 for ten. https://www.amazon.com/gp/product/B0...?ie=UTF8&psc=1

How did you remove it? I need to replace one that is either burnt out or has a bad connection. Any help would be appreciated!

[wmurphy]

I used a small flat bladed screwdriver to gently pry the light bulb out, the the rubber grommet. Installation was grommet first then LED popped right in. I used heat sealing butt connectors for the wiring.

[jyh818]

Originally Posted by wmurphy

I replaced all of the front clearance lights after a couple had cracked/broken lenses. I found these on Amazon and the fit perfectly. They are much brighter than the stock lights and have held up well. I also used them on my UTV as turn front turn signals with no issues. Way cheaper than OEM. $10.95 for ten.

https://www.amazon.com/gp/product/B0...?ie=UTF8&psc=1

I just received these amber marker lights and will be putting them on soon. One of lenses on my current one fell off somewhere. Didn't notice it until I just so happen to look up there.

These are directional, meaning that only one wire is positive 12V and one wire is ground. You can't reverse it. The black wire just so happen to be the positive, while the white wire is ground (like wiring in the house).