Where to locate surge protector in Melbourne 24K?

[krmorris]

I am thinking about installing internal surge protector - EMS-HW30C. Where is the best location to install? I do not relish taking the RV apart to figure that out. The fuse panel is under the rear bed. There is also a boxed space approximately where the power enters the RV.

[Sundancer330]

My panel is also under the bed so that was an easy location to cut the cable and mount the EMS, simple less than 30 minute job

[Pfflyer]

If I was going to hardwire one in I would either do under the bed or in the pass through compartment on the rear wall on the other side of the 30amp inlet. Either way I think you will need a short piece of wire unless yours has a remote status display. If that is the case under the bed would be my choice.

[21JaycoMelbourne24k]

how do you remove the bed panels to access that slot? I found plywood under the top nice paneling, but the slide is on top of that.