355mbqs kitchen slide wall

[hymanykd]

Just a question, how much flex of the main interior wall do people get slide in vs out? Reason I ask is I have a gap between my cabinets on the inside wall when the slide is out of about 1/8 to 3/16 of an inch. The flex would seem somewhat normal as the slide is hanging off the side of the trailer. I have checked everything, all is tight no bent out riggers, slide has no strain in or out, the odd sync issue, no mor or less.

More of a curiosity than anything. Trailer is a 2015.

Thanks.

[DAD]

Had the same issue. When slide was out I had a gap between outside wall and pantry. It got bigger, the gap, started to show gap between vanity and wall in 1/2 bath behind pantry. Took it back to factory due to fact no dealer was capable of accomplishing any. thing. Told the service writer about it along with 15 other things, he knew instantly what was wrong with it. This must be pretty common. When they run the screws up into the side wall from the bottom, they miss 50% of the screws into the bottom of sidewall. Notice a gap between the molding up vertically and than curves forward under overhang when on the pin, but not on landing legs? Same problem. This is not the first time both above mentioned items have been on this forum.

[hymanykd]

Tried searching through the forum and can’t find anything regarding wall movement. If someone can send me to the post it would be appreciated

[DAD]

The posts I mentioned did not address the problem, only that they also had gap when slide open, or obvious movement under overhang. Take it in and have them check what I said

[TxLoser]

I feel like we need a slide sub forum.

[AKRUEBBE]

Originally Posted by TxLoser

I feel like we need a slide sub forum.

x2