377 voyager rearview camera ?

[Palle-man]

I have read on posts that there is a switch for the camera. I can't get ours to pair to the monitor and was wondering if this is the problem.

[Rock]

There is no switch on my unit that I can find.

[Rock]

Spent last night pulling fuses to see where my FBTS back up camera gets its power. On my unit it is 15 amp fuse labeled rear overhead counter, hitch& trunk
Did not know I had a trunk. Looks like they wired the camera to the hot lead going to the light switch on the left rear above the rear couch since it is a short run. I will pull the switch after work and if that is what they did I will install a second switch for camera. Pretty stupid to have ur camera powered 24/7 anytime battery disconnect is on. Just another battery drain and not good for camera ir lights. Also noticed that the fuse for the radio is not to the radio as listed it is two fuses forward to other stuff. Found that when radio went out but was still two fuses forward of the label that said radio. Point being I will not trust the labeling and will check all fuses if a 12 volt item becomes inop before chasing wires.
Rock

[klassic]

I have the 12v schematic for my rig, which would be close to yours for the most part.
The fuse you speak of goes directly to the switch which powers the two lights above the couch, then around all the way back to the light in the water compartment, then to the light in the basement, all the way to the front cap LED strip, around to the light in the curb side basement. (AKA "trunk")

It doesn't show it going to the camera, but there is no wire showing for the camera.

[Rock]

klassic
The wiring diagram I got for mine sucks. It shows the switch on the other side of my Rv but has no wiring going to it. I have 12 diagrams from Jayco and I am not impressed by any of them. I know schematics I an an an airframe power plant mech and a retired USCG AMCM and what they gave me is detailed but not to specs. I pulled the switch today and just hot an ground wire going to it. I am calling Jayco in the morning to find out where they taped into. I am wondering if they ran all the circuit to a buss bar and than to the fuse panel. I am not gonna rip everything a part to find it. As a last resort I will cut the exposed wires from the cap to camera and splice in a water proof switch. They r cutting to many corners. My other option is to pull the whole electrical panel and see if the ran separate wires to that fuse. On another note u need to pay attention to sealing ur wheel wells. The pic u posted of ur slide wires for me u have a bunch of wood showing and will be water soaked in no time towing in the rain. And I know ur small head will fit in the wheel well to see it. Lol
Rock

[klassic]

Hahaha.. I did see that in the picture. I was waiting till the weekend to close the slide to see if it would get wet.
Thanks for the reminder, I had forgotten. It's hard to keep that much memory when a head is this small. Remind me again on Saturday.

[Rock]

Will do.

[Rock]

Tried calling Jayco today after work but to late. There tech dept closed at 1600. Wanted to do a switch tomorrow. Oh well
Rock