Factory installed toppers
We purchased a 2019 Eagle 355MBQS in April and ordered it with slide toppers installed at the factory. When we went to pick it up, the topper on the bunk room pulled out of the exterior wall of the slide-out. Dealer removed it, repaired the siding, and re-installed it "right" only to have it start to pull out of the slide-out a month or so later. This time we were told the new factory installed toppers have brackets that don't keep the topper far enough away from the siding and it ends up rubbing and catching while the slide-out tries to extend and retract. This time they replaced it with an after market topper and we've had no troubles since.
But now we have our big slide-out (kitchen) starting to act up. It starts to extend, then stops, but by releasing and pressing the button it will continue. I went to look at the topper and sure enough, there's a bow in it and while it's off the siding at the ends, it's up against the siding in the middle. Could that topper be the the cause of the slid-out stopping when trying to move? I see the same bowing on the other long slide-out but not on the shorter BR topper.
Anyone else had trouble with the factory installed toppers?